Go Back
+ servings

Grill Roasted Leg of Lamb Recipe


grilled leg of lamb
Tried this recipe?Tell others what you thought of it and give it a star rating below.
4.39 from 100 votes
This recipe shows how to grill a bone-in leg of lamb, but it's easily adapted for BBQ boneless or butterflied leg of lamb.
Serve with: Roasted red peppers, potatoes, grilled zucchini, and a big red wine like Zinfandel or Syrah.

Course:
Dinner
,
Lunch
,
Main Course
Cuisine:
American
difficulty scale

Makes:

Servings: 8 servings

Takes:

Prep Time: 45 minutes
Cook Time: 2 hours
Dry Brining Time: 12 hours

Ingredients

Notes:
About the lamb. A typical bone-in leg of lamb will usually be in the 8 to 9 pound (3.6 to 4kg) range, perhaps smaller in spring. After trimming and removing the aitchbone, you'll have a hunk of meat weighing about 6 pounds (2.7kg). Remove the leg bone and you will have about 5 pounds (2.2kg) of trimmed meat. There will be about 20% shrinkage while cooking.
About the salt. Remember, kosher salt is half the concentration of table salt so if you use table salt, use half as much. Click here to read more about salt and how it works.
Optional. I really like lamb with fire roasted red bell peppers. They go together like bedtime and counting sheep. You'll need about 4 large ones for a leg. You can do them days in advance or while you are cooking the lamb. You'll serve these on the side but they will often find their way onto a fork with some lamb.
Metric conversion:

These recipes were created in US Customary measurements and the conversion to metric is being done by calculations. They should be accurate, but it is possible there could be an error. If you find one, please let us know in the comments at the bottom of the page

Method

  • Prep. Start the day before if you can by removing as much of the thick fat cap on the surface as possible and all the silverskin underneath. Remove the bones, or not. Your choice.
  • Now gash the surface by stabbing it repeatedly about 1/2" (13mm) deep and 1" (2.5cm) apart or run a sharp blade across the surface in a checkerboard pattern making squares 1 to 2" (2.5 to 5cm) wide. Click here to read more about the technique of gashing. Sprinkle the salt all over the meat going lighter in the thinner areas. This is called dry brining. Click here to learn more about the concept. Now use butcher string and tie the whole floppy mess into as much of a log shape as possible so it will cook evenly. Your string and knots are going to look sloppy, and you may have problems with loose flaps of meat on the ends, but get them tucked in. I've been known to use toothpicks, and even turkey lacers (shown here). Put it in a pan, and leave it in the fridge overnight.
    turkey lacers
  • Make the Dolly's Lamb Rub And Paste and swab the paste all over the meat and deep into the gashes.
  • Fire up. Preheat the cooker in a 2-zone setup so the indirect side is about 225°F (107°C). I know a lot of recipes call for higher temps, but I'm here to tell you, this cut performs much better at low temps so the tough connective tissues and copious fat can liquefy (read more about this concept in my article about meat science). If you have a digital thermometer with a probe that can be left in, insert it now. If you are cooking bone-in, make sure your thermometer probe is about 1" away from the bone in the thickest piece of the meat. If you wish to add some smoke flavor, add a small amount of dry wood now, perhaps a handful, depending on your cooker. The more ventilation the more wood.
    boneless leg of lamb on grill with bricks to crisp the edges
  • Cook. Place the leg of lamb on the indirect side and cook with the lid down until the meat hits about 110°F (43°C). Then move the whole clod of meat over to the direct heat side and sear it until it is dark on all four sides or until the meat is 130 to 135°F (54 to 57°C) max. In the photo above you can see how I used a pair of bricks wrapped in foil to hold the roast on edge and get an all-over sear.
  • Prep again. While the meat is cooking, prepare a board sauce, heavy on rosemary and/or mint. You can make it in a bowl or cup.
  • Pour the board sauce on the board, plop the meat on top of it and start carving. You want the juices to mingle with the sauce.
  • Serve. Carve the meat across the grain into 1/4" (6mm) slices as needed and let the meat get plenty of sauce on it just before serving.