When preparing ribs at home, one of the key factors to achieving perfection is knowing when they are properly done (and no, this does not mean “fall off the bone”!).
There is an old joke among some competition cooks about how to tell if the ribs are ready. Take one slab of spareribs and one slab of baby back ribs and put them both in the smoker. When the baby backs are dry, the spareribs are done.
OK. Maybe that’s a bit extreme. But it underlines how hard it is to tell when ribs are ready. That’s because ribs come in so many different weights and thicknesses. Not to mention the fact that keeping an outdoor oven at a precise temp is tricky. So here are some guidelines and techniques for telling when they are done (click here for a Food Temperature Guide for other meats).
Hungry for more ribs recipes, tips, and techniques? Click here to download our ebook “Amazing Ribs Made Easy” $3.99 on Amazon (free Kindle app runs on all computers and devices). Or, get this book and others FREE as a member of the AmazingRibs.com Pitmaster Club. Click here to join.
Done or ready?
I differentiate between “done” and “ready,” a fine semantic line, but an important one when it comes to barbecue.
Meat is “done” when the temperature at its thickest point reaches the point at which it is safe to eat. That doesn’t mean it’s “ready”, though.
According to USDA, ribs are “done” when they are 145°F internal temp, but they may still be tough. If you take them up to 190 to 203°F, the collagens and fats melt at this temp and make the meat more tender and juicy. Then they’re ready! See the diff?
Notice the sign here from the side of a smoker at Dinosaur Bar B Que in Rochester, NY. There are temperatures and tactile tests the pitmasters use.
How do I know when my ribs are ready? I work hard to control my cooking temperature. I use a quality digital thermometer and shoot for at least 190°F and like to go to 203°F. For ribs there is not much use in trying to read the temp of the meat. It is too thin and varies in thickness from end to end and side to side. In addition the meat next to the bone can be warmer than in the middle of the bones. I keep the oven probe near the meat, but not on the meat. I watch the clock. When they I think they are ready, I use the bend test (described in more detail below).
For more on meat science, click here.
Ribs should not fall off the bone!
Properly cooked ribs will not not not fall off the bone! The only ribs that fall off the bone are ribs that have been boiled and steamed and that process usually robs them of flavor because water is a solvent. Steamed and boiled ribs usually have a mushy texture. Properly cooked ribs will pull cleanly off the bone with your teeth, but they will still have some resilience and chew, like a properly cooked steak, but not be tough. Remember, boiling meat is the way to make flavorful soup, not flavorful meat.
How to tell when they are ready
Every grill and smoker is different and every slab of meat is different, so exact cooking time depends on a number of variables. I use a thermometer, but also use some other techniques.
Spotlight on our favorite products
The Pit Barrel Cooker May Be Too Easy
The PBC has a rabid cult following for good reason. It’s among the best bargains for a smoker in the world. This baby cooks circles around cheap offset smokers because temperature control is so much easier. Click here to read our detailed review and the raves from people who own them.
– THIS IS NOT AN AD –
The time test. The ideal cooking temp is about 225°F, hot enough to brown the surface, to develop a crusty bark, and to melt fat and collagens. On most cookers, when the oven temp is 225°F at sea level, it takes about 4 to 5 hours to cook a slab of baby backs and about 6 to 7 hours to cook a slab of St. Louis cut ribs or spares. This can vary depending on the thickness of the slab.
They are slightly undercooked at that stage. I then put the sauce on and sizzle it in on a hot grill for about 5 minutes per side (click here for saucing strategies). This finishes the cooking and makes sweet sauces taste their best. But you have to stand there and watch them so the sauce won’t burn. If you skip the sizzling step, add another 30 minutes of cooking time at 225°F.
At higher cooking temperatures decrease the cooking time. For example, at 325°F, baby backs can be done in only 90 minutes, but there will be shrinkage and they will be tougher. At higher altitudes, increase the cooking time 20% or more. The key here is to keep the cooking temp under control, and that is the barbecue chef’s craft.
That said, it should be noted that each slab is different, and some can take a good bit longer. In the words of one of Merrill Powers, known as Captain Que to his friends, “they’re done when they’re done!”
The bend test. This is the method I like best. I pick up the slab with a pair of tongs near the center and bounce them slightly. If they are ready, the slab will bow until the meat starts to crack on the surface. A small crack means you need a little more time. It should be close to breaking when you lift the slab. You’ll get the feel for this with practice.
The twist test. Another technique is to grab ahold of the tip of a bone somewhere near the middle. If you twist, it should start to break free of the meat. This means the collagens in the tough connective tissues have melted and turned to gelatin.
The popup test. A lot of books and websites say to wait until the meat begins to pull back from the tips of the bones, exposing about 1/4″ of bare bone as in the picture at right. Some folks call this the natural popup thermometer. Problem is that this is not necessarily a sign that they are ready. Heat can cause this shrinkage. Put ribs on a hot grill and they will shrink within an hour, but they won’t be done. On the other hand, if you keep the temp under 250°F, by the time the meat pulls back, it is overcooked.
The peek-a-boo test. If you are unsure if the meat is ready, you can cut into it and sneak a peek. The meat in the center should be white and there should be no pink juices. Remember, if you have cooked with smoke, there will probably be pink meat near the surface, but the meat in the center should be white or tan. Click here to see a perfect rib.
The taste test. Some cooks pull one bone off the end, look at the meat, and then taste it. This works fine, especially because you get to eat the rib you removed! Problem is when the meat is not ready. Then you have to pull off another bone. Then another. Then there’s nothing for the guests.
The toothpick test. Jack Waiboer, a champion cook from South Carolina likes the toothpick method for his recipe. “You poke a toothpick into the meat between the bones. When it slides in with little or no resistance you have a done rack of ribs. It’s best to test various parts of the rack to be sure you have them done to your liking. With a little practice you can better judge the doneness of your ribs than the bend test. I hesitate to use the word accurate in a barbecue conversation. After a few beverages accuracy seems to depend on the quality of the bourbon.”
High quality websites are expensive to run. If you help us, we’ll pay you back bigtime with an ad-free experience and a lot of freebies!
Millions come to AmazingRibs.com every month for high quality tested recipes, tips on technique, science, mythbusting, product reviews, and inspiration. But it is expensive to run a website with more than 2,000 pages and we don’t have a big corporate partner to subsidize us.
Our most important source of sustenance is people who join our Pitmaster Club. But please don’t think of it as a donation. Members get MANY great benefits. We block all third-party ads, we give members free ebooks, magazines, interviews, webinars, more recipes, a monthly sweepstakes with prizes worth up to $2,000, discounts on products, and best of all a community of like-minded cooks free of flame wars. Click below to see all the benefits, take a free 30 day trial, and help keep this site alive.
Post comments and questions below
1) Please try the search box at the top of every page before you ask for help.
2) Try to post your question to the appropriate page.
3) Tell us everything we need to know to help such as the type of cooker and thermometer. Dial thermometers are often off by as much as 50°F so if you are not using a good digital thermometer we probably can’t help you with time and temp questions. Please read this article about thermometers.
4) If you are a member of the Pitmaster Club, your comments login is probably different.
5) Posts with links in them may not appear immediately.